Brep.Trim()

@PhilO wrote:

Hi everyone,

I have been running into some issues with using Brep.Trim(Plane, tolerance).

I attach an example file in grasshopper - it shows a large radius fillet surface which got extended a bit in previous step of the definition and tries to trim it with a plane, the routine Brep.Trim() does not yield any results whereas a standard grasshopper Brep Section component shows that there should be an intersection.

I tried this in both Rhino 5 as well as in Rhino 6 Trial - same result.

If this method has a problem - are there any alternatives in rh 5 and rhinocommon ?

Best,
Philipp

BrepTrim_RH_5_GH_0.9.0069.gh (59.4 KB)
BrepTrim_RH_6_GH_1.0.gh (59.5 KB)

Posts: 1

Participants: 1

Read full topic