Should the ExtrudeSurface method be influenced by the curve direction?

@DanBayn wrote:

I noticed that I can get different results when extruding a surface depending on the curve direction. To me this doesn’t make sense. This is how the method is supposed to work according to the help file:

But this is how it actually works:

image768×432 12 KB

image844×654 15.4 KB

But if I flip the direction of the curve, the extrusion is created where I would expect it to be (following the curve).

image790×462 13.9 KB

This doesn’t seem like it’s working correctly to me. I don’t think the curve direction should be a factor at all.

Thanks,

Dan

Posts: 1

Participants: 1

Read full topic